Filter Press Frame

- Nov 16, 2018 -

The frame is the basic component of the filter press. The two ends are the thrust plate and the pressing head. The two sides of the girders are attached to each other. The girders are used to support the filter plate, the filter frame and the pressing plate.

1. Thrust plate: It is connected with the support. One end of the filter press is located on the foundation. The middle of the thrust plate of the box filter press is the feed hole. There are four holes in the four corners. The hole is the washing liquid or the press gas inlet, and the lower two corners are the outlet (underflow structure or filtrate outlet).

2. Pressing plate: used to press the filter plate filter frame, and the rollers on both sides are used to support the pressing plate to roll on the track of the beam.

3. Girder: It is a load-bearing component. It can be coated with hard PVC, polypropylene, stainless steel or new anti-corrosion coating according to the requirements of environmental protection.